![]() ![]() FebruTutorials 10.8.2, 10.8.3, 64 bit, Atheros GbE LAN, GA Z77-DS3H, Gigabyte, hackintosh, Intel HD2500, Intel i5 3470, Intel Z77, Mountain Lion, Nvidia GTX 650, OCZ Vertex 4, os x install, Realtek ALC887, UEFI Bios murdah. Fusion Drive Setup for a Hackintosh - A tutorial from MacBreaker that covers the process of configuring a Fusion Drive on a "Mountain Lion" Hackintosh system. The same blogger also covers how to switch from BIOS to UEFI on a compatible Gigabyte. I put it all together, and then booted with a Linux optical disk to verify that everything worked. I updated my BIOS sometime back and never had any issues since. Different manufacturers set different keys for opening the BIOS. However, I suspect during that BIOS update, it must’ve reset settings to safe-boot mode or similar which wipes out some of the config’s I had there. You’ll need to navigate to the right folder within your drive that contains your BIOS update that we just copied over previously. Configuring SATA controller mode in BIOS Setup Make sure to configure the SATA controller mode correctly in system BIOS Setup. On Gigabyte motherboards, you can reset your BIOS settings to their default by selecting "Load Optimized Defaults" on the main page of the BIOS. Before starting, reset all of your BIOS settings to their factory defaults. If your Hackintosh doesn't have any version of Mac OS X installed yet, you have to change a few extra BIOS settings. Clover … As my modules are rated to run at 3200 MHz with XMP, I went into BIOS->M.I.T. YOU MUST modify SN/UUID/MLB/ROM values in ist file. ![]() How to Install Retail Mac Os X 10.8.2 Mountain Lion on Gigabyte GA Z77-DS3H + update to 10.8.3. Q-Flash comes with all Gigabyte motherboards, and it’s the built-in utility that makes it easy to start a BIOS update. How to correctly setup BIOS for your Hackintosh, built on top of GIGABYTE motherboard. Before you commence the installation of the Mac OS on a PC, there are some settings in the BIOS you’ll have to configure. i5-10400 + Gigabyte H410M H + AMD Radeon RX 5500 XT + Hackintosh Big Sur + OpenCore 0.6.3 hackintosh gigabyte opencore i5-10400 Updated Hackintosh Legacy BIOS Settings. On Gigabyte motherboards, you can reset your UEFI settings to their default by pressing the "F7" key. Gigabyte hackintosh bios settings Advanced Frequency Settings and enabled XMP to Profile 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |